SuperSips Ltd

SuperSIPs are a dynamic Structural Insulated Panel manufacturer based near Ipswich.

The owners have over 50 years' experience in the Building Industry and almost 20 years' experience in SIPs and associated industries.

SuperSIPs can help with the integration or combination of many complementary products, from Ground Source Heat Pumps to Under Floor Heating, from Mechanical Ventilation & Heat Recovery, to Solar Hot Water.

SIPs provide the ideal Building Fabric for the incorporation of many Energy Saving and Money Saving products.

With SIPs being suitable for such a wide variety of buildings, no job is too small or too large!

Our services encompass everything from Initial Enquiry to Completion; which can include Design, Structural Engineering, Production, Preparation, Delivery and On-Site Erection, using all our own staff, equipment & transport.

In addition, if required, we would be equally able to advise or assist a budding Self Builder or provide additional Services, from Ground Works to Topping Out for any Project.

Basically, whatever the enquiry, whatever the building SuperSIPs can help.

Our Product
SuperSIPs produce SIPS (or Structural Insulated Panels) using a facing of OSB3 (Water Resistant Oriented Strand Board), injected with PUR (Polyurethane) insulation.

These panels offer Labour & Material savings compared to the traditional Timber Frame or Masonry Construction.

The insulation used in our panels is continuous and not bridged by timber studs.

This type of Panel has been in use for over 50 years and offers an energy efficient Building System that substantially reduces on-site labour time & cost.

SIPs are made by pressure injection; a process that consistently produces a high quality product and virtually eradicates manufacturing/operator errors. At SuperSips delamination of SIPs is simply not an issue!!

SIPs can be used as Structural Walls, Floors, Roofs & Internal Partitions, either together or independently. They can also be used in Timber or Steel framed buildings, however the greatest savings in time, energy & materials used; is achieved when the complete structure is made with SIPs.

Any type of conventional finish can be applied to a SuperSips building shell.

SuperSIPs offer one of the highest levels of Thermal Performance of any readily available, off-site manufactured building material. See our Building Materials comparison Stack on our Website for more information.

Thermal efficiency is maintained throughout a building's life when our Sips are used. The closed cell foam does not allow moisture ingress to degrade the insulation performance, as can occur with Mineral Wools and Blown Cellulose Fibre products.

A house built with SuperSips will give energy savings of 40%-60% compared to a timber framed house of equal size and insulation U-value.

SuperSips offer a full design & engineering service and can make Custom Panels, if required.

Ready To Assemble Panels (RTA) can be provided by pre-cutting openings, edges, angles, and other complex shapes, delivered to your site, ready for installation.

We can also advise you and/or your builder how to proceed with the construction.

With SuperSIPs you can plan to meet, or exceed, current Building regulations; and the amendments planned for 2016.

Benefits of SuperSips

• High Levels of Thermal Performance
• High Levels of Air Tightness
• Low Levels of Waste
• Off-site Manufacture
• Fast On-Site Erection
• Reduced Construction Costs
• Meet 2016 Building Standards
• Can be used to build just about anything!

Product Information

Sizes

All SuperSips panels start life as 1.22m wide panels and are available in various lengths: 2.44m, 2.7m, 3.0m, 4.8m, 5.4m & 6.3m. These can be cut to produce panel to suit any location in your plan.

Thickness

SuperSips panels are most commonly produced in the following thicknesses: 100mm, 125mm, 150mm & 175mm. They are also available 200mm, 225mm & 250mm thick if required.